For technical reasons we only offer the standard tile mirror measure in the height of 60cm as well as the widths stated in the offer.
Unfortunately we can not offer this for an extra charge due to technical reasons.
If necessary, our product can really be easily adjusted with sharp ...
The material can be very easily cut with sharp scissors.
It is best to make a straight line across the width or length with a permanent marker in advance.
Afterwards, simply "pull through" with scissors 2mm next to the marked line. (Recommendation: Dahle Professional Dahl 50010) ...
There are e.g. at Ikea wall end strips by the name "Fixa". These are 2.5cm high and can be used as edge molding and possibly even bridge up to 2cm height differential.
www.ikea.com/de/de/catalog/products/40246038/
The Premium version is very stiff, so it can not be folded around corners or "kinked".
Therefore, at the corners you must cut the material apart with a sharp cutter or scissors. Then the kitchen splashback parts are applied on butt.
If desired, you can use silicone to seal the seam. ...
We recommend the following tools that we have tested for many years to install your kitchen splashback:
Craft knife: Olfa ARL5-AL Craft knife
Scissors : Dahle Professional 50010
Sticky tape: Tesa Premium CLASSIC crepe tape
Latex paint is a critical surface with regard to the bonding of any adhesive product.
Normally, our kitchen splashback from the PREMIUM series adheres on Latex paint. But we've also had the case that it didn't adhere to latex paint.
The following note about the so-called "elephant skin" ...